Chainsaw Man Reze Statue with LED: Unboxing and Setup Guide

By Global Hub for Resin Statues, Anime Figures-figurechoice | Published: 2026-10-26

Category: How-to Guides

Learn how to unbox and set up your 1/6 scale Reze LED resin statue from HeRa Studio. Step-by-step instructions, common mistakes, and display tips.

Quick Answer

To get the best out of your Reze LED statue, unbox carefully, check all parts against the manual, and test the LED before final placement.

Why LED Resin Statues Need Extra Care

LED components and resin are both delicate. The wiring inside the statue can be damaged if you pull or twist it during unboxing. Resin can chip if dropped, especially at the base edges.

This 1/6 scale Reze statue is a limited edition of 99 pieces per version, so a careful setup protects your investment and keeps the piece display-ready.

What to Know Before You Start

The statue ships with a resin body and a separate base that houses the LED. You'll need a small Phillips screwdriver for the battery compartment and a soft cloth to handle the resin without leaving fingerprints.

Plan your display spot before unboxing so you don't have to move the statue once it's assembled. LED resin statues look best on a shelf at eye level with a power source nearby.

Unboxing and Setup Steps

Prepare your workspace: Clear a flat, soft surface with good lighting. Have a soft cloth, small screwdriver, and the manual ready. Check that you have the correct batteries for the LED base. A clean, soft surface prevents scratches and makes small parts easier to track.
Open the outer box and inspect: Cut the tape carefully, lift the lid, and remove the inner foam. Check the statue, base, and accessories against the manual. Note any missing pieces before you proceed. Take photos of the contents for your records in case you need to contact support.
Remove the statue from the foam: Gently lift the statue by its base or thickest part, not by the head or limbs. Avoid touching the LED wiring. Place it on the cloth. Never pull on the LED cable; it can disconnect from the battery compartment.
Install the batteries and test the LED: Open the battery compartment on the base, insert batteries as shown in the manual, and switch on the LED. Confirm the light works before final assembly. If the LED doesn't light, check battery polarity and contact points before assuming a defect.
Assemble the statue onto the base: Align the pegs or slots on the statue's feet with the base. Press down evenly with gentle, even pressure until it sits flush. Do not force it. If it doesn't fit, remove the statue and check for debris or misalignment, not force.
Place the statue and style the display: Position the statue on your chosen shelf away from direct sunlight and heat. Arrange any included accessories. Keep the LED on for short periods to preserve battery life. Rotate the statue occasionally to prevent dust buildup, and keep the box for storage.

Product Facts

1/6 Scale Reze with LED - Chainsaw Man Resin Statue - HeRa Studio: This 1/6 scale Reze statue is made of resin and PU, measures H28cm x W13cm x D14.8cm, and is limited to 99 pieces per version. The compact size fits most display shelves, and the limited run means careful handling is worth the effort to keep it in mint condition.
1/6 Scale Reze with LED - Chainsaw Man Resin Statue - HeRa Studio